2008 Jeep Liberty Owner's Manual - Page 149
2008 Jeep Liberty Manual
Page 149 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 149 To Resume Speed: If you deactivated the speed control without erasing the set speed from memory and your vehicle speed is above 20 mph (32 km/h) you can resume the previous set speed. To do so, push the lever up and release (RESUME ACCEL), and then remove your foot from the accelerator pedal. To Vary The Speed Setting: When the speed control is set, you can increase speed by pushing up and holding the lever ("RESUME ACCEL"). Release the lever when the desired speed is reached, and the new set speed will be established. Tapping ("RESUME ACCEL") once will result in a 1 mph (2 km/h) speed increase. Each time the lever is tapped, speed increases so that tapping the lever three times will increase speed by 3 mph (5 km/h), etc. To decrease speed while the speed control is set, push down and hold the lever ("SET DECEL"). Release the lever when the desired speed is reached, and the new set speed will be established. Tapping the ("SET DECEL") button once will result in a 1 mph (2 km/h) speed decrease. Each time the button is tapped, speed decreases. To Accelerate For Passing Depress the accelerator as you would normally. When the pedal is released, the vehicle will return to the set speed. Using Speed Control On Hills NOTE: The speed control system maintains speed up and down hills. A slight speed change on moderate hills is normal. On steep hills, a greater speed loss or gain may occur so it may be preferable to drive without speed control. 3