2008 Jeep Liberty Owner's Manual - Page 302

302 STARTING AND OPERATING position, make certain all shift requirements have been met, wait five (5) seconds, and try the shift again. 2WD to 4WD Auto Move the 4WD Control Switch to the desired position. Shifts between 2WD and 4WD Auto can be done with the vehicle stopped or in motion. If the vehicle is stopped, the ignition switch must be in the ON position with the engine either OFF or RUNNING. This shift cannot be completed if the ignition switch is in the ACC position. 2WD or 4WD Auto to 4WD Low When shifting into or out of 4WD LOW, some gear noise may be heard. This noise is normal and is not detrimental to the vehicle or its occupants. Shifting can be performed with the vehicle rolling 2-3 mph (3-5 km/h) using the "Preferred Procedure" or completely stopped using the "Alternate Procedures." Preferred Procedure 1. With the engine RUNNING, slow the vehicle speed to 2-3 mph (3-5 km/h). 2. Shift the transmission into "N" (Neutral) (automatic transmission), or depress the clutch pedal (manual transmission). 3. While still rolling, move the 4WD Control Switch to the desired position. 4. After the desired position indicator light is ON (not flashing), shift the transmission into gear (automatic transmission), or release the clutch pedal (manual transmission). Alternate Procedure 1. Bring the vehicle to a complete stop.