2013 Jeep Grand Cherokee Owner's Manual - Page 266

264 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Firmly press and release the "LEARN" or "TRAIN- Reprogramming A Single HomeLink® Button ING" button. On some garage door openers/devices To reprogram a channel that has been previously trained, there may be a light that blinks when the garage door follow these steps: opener/device is in the LEARN/TRAIN mode. 1. Cycle the ignition to the ON/RUN position. NOTE: You have 30 seconds in which to initiate the next 2. Press and hold the desired HomeLink® button until step after the LEARN button has been pressed. the indicator light begins to flash after 20 seconds. Do not release the button. 6. Return to the vehicle and press the programmed HomeLink® button twice (holding the button for two 3. Without releasing the button proceed with "Programseconds each time). If the garage door opener/device ming A Rolling Code" Step 2 and follow all remaining activates, programming is complete. steps. NOTE: If the garage door opener/device does not acti- Programming A Non-Rolling Code vate, press the button a third time (for two seconds) to For programming Garage Door Openers manufactured complete the training. before 1995. To program the remaining two HomeLink® buttons, repeat each step for each remaining button. DO NOT 1. Cycle the ignition to the ON/RUN position. erase the channels. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view.