2013 Jeep Grand Cherokee Owner's Manual - Page 347

UNDERSTANDING YOUR INSTRUMENT PANEL 345 mode the Blind Spot Monitor (BSM) will show a visual alert in the outside mirrors as well as an audible alert When this feature is selected, the HSA system is active. when the turn signal is on. When "Blind Spot: Off" is Refer to "Electronic Brake Control System" in "Starting selected the Blind Spot Monitor (BSM) system is deactiAnd Operating" for system function and operating inforvated. mation. To make your selection, press and release the SELECT button until a check-mark appears next to the NOTE: If your vehicle has experienced any damage in feature showing the system has been activated or the the area where the sensor is located, even if the fascia is check-mark is removed showing the system has been not damaged, the sensor may have become misaligned. deactivated. Take your vehicle to an authorized dealer to verify sensor alignment. Having a sensor that is misaligned will result Blind Spot Alert - If Equipped in the BSM not operating to specification. There are three selections when operating Blind Spot Alert. By pressing and releasing the SELECT button once, Forward Collision Warning - If Equipped the Blind Spot Alert feature can be activated in "Blind The Forward Collision Warning (FCW) feature can be can Spot: Lights Only" mode. When this mode is selected the be set to Far, set to Near or turned Off. The default status Blind Spot Monitor (BSM) system is activated and will of FCW is the Far setting. This means the system will only show a visual alert in the outside mirrors. By warn you of a possible collision with the vehicle in front pressing and releasing the SELECT button a second time of you when you are farther away. This gives you the "Blind Spot: Lights/CHM" mode is activated. In this most reaction time. To change the setting for more Hill Start Assist (HSA) - If Equipped 4