2013 Jeep Grand Cherokee Owner's Manual - Page 473

STARTING AND OPERATING 471 NOTE: If shift conditions/interlocks are not met, or a NOTE: transfer case motor temperature protection condition • If shift conditions/interlocks are not met, or a transfer exists, a "For 4x4 Low Slow Below 3 MPH or 5 KPH Put case motor temperature protection condition exists, a Trans in N Press 4 Low" message will flash from the "For 4x4 High Slow Below 3 MPH or 5 KPH Put Trans Electronic Vehicle Information Center (EVIC). Refer to in N Press 4 Low" message will flash from the Elec"Electronic Vehicle Information Center (EVIC)" in "Untronic Vehicle Information Center (EVIC). Refer to derstanding Your Instrument Panel" for further informa"Electronic Vehicle Information Center (EVIC)" in tion. "Understanding Your Instrument Panel" for further information. 4WD LOW To 4WD HI With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the • Shifting into or out of 4WD LOW is possible with the ignition switch in the ON position or the engine running, vehicle completely stopped; however, difficulty may shift the transmission into NEUTRAL, and press the occur due to the mating clutch teeth not being prop"4WD LOW" button once on the transfer case switch. The erly aligned. Several attempts may be required for "4WD LOW" indicator light in the instrument cluster clutch teeth alignment and shift completion to occur. will flash and go out when the shift is complete. The preferred method is with the vehicle rolling 0 to 3 mph (0 to 5 km/h). If the vehicle is moving faster than 3 mph (5 km/h), the transfer case will not allow the shift. 5