2008 Mercedes CLK-Class Owner's Manual - Page 81
2008 Mercedes CLK-Class Manual
Page 81 highlights
Safety and Security Occupant safety intensity for a maximum of 60 seconds or until the driver's and the front passenger's seat belt are fastened. If you and/or your passenger release the seat belt during driving, the seat belt telltale < starts flashing and a warning chime sounds as described before. If the driver's or the front passenger's seat belt remains unfastened after 60 seconds, the warning chime stops sounding, the seat belt telltale < stops flashing but continues to be illuminated. After a vehicle standstill, the warning chime is reactivated and the seat belt telltale < is flashing again if the vehicle speed once exceeds 15 mph (25 km/h). The seat belt telltale < will only go out if both the driver's and the front passenger's seat belt (with the front passenger seat occupied) are fastened, or the vehicle is standing still and a door is opened. For more information, see "Practical hints" ( page 385). Emergency tensioning device (ETD), seat belt force limiter The seat belts are equipped with emergency tensioning devices and belt force limiters. The ETD is designed to activate in the following cases: in frontal or rear-end impacts exceeding the system deployment threshold if the restraint systems are operational and functioning correctly, see 1 indicator lamp ( page 64) When activated, emergency tensioning devices remove slack from the belts. Belt force limiters reduce the force exerted by the seat belts on occupants during a crash. Warning! G An emergency tensioning device (ETD) that was activated must be replaced. When disposing of the emergency tensioning device, our safety instructions must be followed. These are available at any authorized Mercedes-Benz Center. Automatic comfort-fit feature seat belt An automatic comfort-fit feature for front seats reduces the retracting force of the seat belts when they are in normal use. i The ETDs for the front seats will only activate if the front seat belts are fastened (latch plate properly inserted into buckle). The ETDs for the rear seats will activate with or without the respective seat belts fastened. 80