2011 Mercedes CL-Class Owner's Manual - Page 148
2011 Mercedes CL-Class Manual
Page 148 highlights
146 Navigation Entering an intermediate stop Introduction When route guidance is active, you can enter an intermediate stop. Intermediate stops can be predefined destinations from the following categories that COMAND offers for selection: RMercedes-Benz RHospital RGas X Service Center Station Lot RRestaurant However, you can also enter destinations other than the predefined ones. To do this, select the menu item Other. You can use the intermediate stop function to influence route guidance to the main destination. When you have reached your intermediate stop, COMAND automatically recalculates the route to the main destination. RParking COMAND To select a category: select a category by turning cVd the COMAND controller and press W to confirm. COMAND first searches in the selected category for destinations along the route. If there are no destinations available there, COMAND searches for destinations within a radius of up to 100 km (approx. 60 mi) of the vehicle position. If COMAND finds destinations, a list appears on the right-hand side of the display. The intermediate stops are listed according to increasing distance from the current vehicle position. They are displayed in the form of a name and their position in relation to the route and your direction of travel. Entering predefined destinations X To switch on navigation mode: press the S function button once or twice. X X i For intermediate stops that are not located along the calculated route, the linear distance is shown. If COMAND does not find any destinations, you will see a message to this effect. X X X Confirm OK by pressing W. Select a different category. Select the intermediate stop by turning cVd the COMAND controller and press W to confirm. To start route calculation: select Start and press W to confirm. To show the menu: press the COMAND controller W. Select Destination in the navigation system menu bar by turning cVd the COMAND controller and press W to confirm. Select Stopover and press W to confirm. X X Option 1: no intermediate stop has been entered yet. X Entering another destination as an intermediate stop X To switch on navigation mode: press the S function button once or twice. X X Select a category, see option 2. Option 2: an intermediate stop has already been entered. X To show the menu: press the COMAND controller W. Select Destination in the navigation system menu bar by turning cVd the COMAND controller and press W to confirm. Select Stopover and press W to confirm. Select Other and press W to confirm. Select Change Stopover and press W to confirm. X X