2011 Mercedes CL-Class Owner's Manual - Page 425
2011 Mercedes CL-Class Manual
Page 425 highlights
Flat tire performing maintenance work under the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. Always firmly engage the parking brake and block the wheels with wheel chocks or other sizable objects before raising the vehicle with the jack. Do not disengage the parking brake while the vehicle is raised. Make sure that the ground on which the vehicle is standing and where you place the jack is solid, level and not slippery. If necessary, use a large underlay. On slippery surfaces, such as tiled floors, you should use a non-slip underlay, for example a rubber mat. Do not use wooden blocks or similar objects as a jack underlay. Otherwise, the jack may not be able to achieve its load-bearing capacity if it is not at its full height. Never start the engine when the vehicle is raised. Also observe the notes on the jack. 423 and in front of the wheel housings of the rear wheels (arrows). G Warning ! The jack is designed exclusively for jacking up the vehicle at the jacking points. Otherwise, your vehicle could be damaged. X Position jack = at jacking point ;. X Using lug wrench :, loosen the bolts on the wheel you wish to change by about one full turn. Do not unscrew the bolts completely. The jacking points for the jack are located behind the wheel housings of the front wheels Z Roadside Assistance The jack is designed exclusively for jacking up the vehicle at the jacking points. The jack saddle must be placed centrally under the jacking point. If you do not position the jack correctly in the jacking point, the vehicle can fall off the jack and seriously or fatally injure you or others.