2011 Mercedes CL-Class Owner's Manual - Page 340
2011 Mercedes CL-Class Manual
Page 340 highlights
338 Menus and submenus Telephone menu Introduction On-board computer and displays You can establish a Bluetooth® connection to COMAND (Y page 179). G Warning A driver's attention to the road must always be his/her primary focus when driving. For your safety and the safety of others, we recommend that you pull over to a safe location and stop before placing or taking a telephone call. If you choose to use the telephone while driving, please use the handsfree device and only use the telephone when weather, road and traffic conditions permit. Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle. Bear in mind that at a speed of just 30 mph (approximately 50 km/h ), your vehicle is covering a distance of 44 feet (approximately 14 m) every second. X Press 6 on the steering wheel to accept an incoming call. If you are not in the Telephone menu, you can still accept a call. Rejecting or ending a call X Press the ~ button on the steering wheel. If you are not in the Telephone menu, you can still reject or end a call. Dialing a number from the phone book You can use the mobile phone to enter new telephone numbers into the phone book (see COMAND) (Y page 187). If your mobile phone is operational, you can select and dial a number from the phone book at any time. When you establish a connection to COMAND via Bluetooth®, COMAND copies the phone book from the mobile phone. This may take some time. While the on-board computer reads in the SIM card: Ryou X Switch on the mobile phone and COMAND (Y page 123). X Press the = or ; button on the steering wheel to select the Telephone menu. You will see one of the following display messages in the multifunction display: RPhone ready or the name of the network provider: the mobile phone has found a network and is ready to receive. RNo Service: no network is available. Accepting a call If someone calls you when you are in the Telephonemenu, a display message appears in the multifunction display, for example: can dial a telephone number from the redial list (Calls Dialed list). Ryou can dial a telephone number from the telephone book stored in COMAND. Rthe multifunction display shows the Reading data...display message below the phone book entries. When the multifunction display shows the Updating data...display message, COMAND has finished importing data. The multifunction display then shows all the phone book entries in COMAND and the mobile phone.