1996 Nissan Pathfinder Owner's Manual - Page 38

1996 Nissan Pathfinder Manual

Page 38 highlights

OPERATING THE TRANSMITTER To operate, simply press the appropriate button on the Integrated HomeLinkTM Transmitter. The red indicator light illuminates while the signal is being transmitted. The effective transmission range of the Integrated HomeLinkTM Transmitter may differ from your hand-held transmitter. CLEARING THE PROGRAMMING INFORMATION To clear the Integrated HomeLinkTM Transmitter of all previous programming information, simultaneously hold down the outside two buttons (#1 & #3) until the red indicator light begins to flash rapidly (approximately 20 seconds). This will clear all three buttons. Individual buttons cannot be cleared, but can be reprogrammed at any time by following the programming procedures described above. cause harmful interference and (2) this device must accept any interference that may be received, including interference that may cause undesired operation. The transmitter has been tested and complies with FCC and DOC/MDC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device. DOC: ISTC 1763K1313 FCC I.D.: CB2V67690 PROGRAMMING PROBLEM DIAGNOSIS Be sure to keep your original hand-held transmitter for possible reprogramming if necessary. ¼ Make sure batteries in the hand-held transmitter are fully charged. ¼ Hold the hand-held transmitter against the bottom surface of the Integrated HomeLinkTM Transmitter so that you can still see the red indicator light. ¼ Hold buttons for duration of the programming without interruption. ¼ Rotate your hand-held transmitter endover-end and program again. For best results, place the end opposite the battery compartment against the Integrated HomeLinkTM Transmitter when programming. IF YOUR VEHICLE IS EVER STOLEN If your vehicle has been stolen, you should change the codes of any device that was programmed into the Integrated HomeLinkTM Transmitter as soon as possible. Consult the owners manual of each device, or call the manufacturer or dealer of those devices. When your vehicle is recovered, you will have to reprogram the Integrated HomeLinkTM Transmitter with your new transmitter information. FCC Notice: This device complies with FCC rules part 15. Operation is subject to the following two conditions: (1) This device may not 1-33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223

OPERATING THE TRANSMITTER
To operate, simply press the appropriate but-
ton on the Integrated HomeLink
TM
Transmit-
ter. The red indicator light illuminates while the
signal is being transmitted. The effective trans-
mission range of the Integrated HomeLink
TM
Transmitter may differ from your hand-held
transmitter.
PROGRAMMING PROBLEM
DIAGNOSIS
Be sure to keep your original hand-held trans-
mitter for possible reprogramming if neces-
sary.
°
Make sure batteries in the hand-held trans-
mitter are fully charged.
°
Hold the hand-held transmitter against the
bottom
surface
of
the
Integrated
HomeLink
TM
Transmitter so that you can
still see the red indicator light.
°
Hold buttons for duration of the program-
ming without interruption.
°
Rotate
your
hand-held
transmitter
end-
over-end and program again. For best re-
sults, place the end opposite the battery
compartment
against
the
Integrated
HomeLink
TM
Transmitter
when
program-
ming.
CLEARING THE PROGRAMMING
INFORMATION
To clear the Integrated HomeLink
TM
Transmit-
ter of all previous programming information,
simultaneously hold down the outside two but-
tons (#1 & #3) until the red indicator light
begins to flash rapidly (approximately 20 sec-
onds). This will clear all three buttons. Indi-
vidual buttons cannot be cleared, but can be
reprogrammed at any time by following the
programming procedures described above.
IF YOUR VEHICLE IS EVER
STOLEN
If your vehicle has been stolen, you should
change the codes of any device that was
programmed into the Integrated HomeLink
TM
Transmitter as soon as possible. Consult the
owners manual of each device, or call the
manufacturer or dealer of those devices.
When your vehicle is recovered, you will
have
to
reprogram
the
Integrated
HomeLink
TM
Transmitter
with
your
new
transmitter information.
FCC Notice:
This device complies with FCC rules part
15. Operation is subject to the following
two conditions: (1) This device may not
cause harmful interference and (2) this de-
vice must accept any interference that may
be
received,
including
interference
that
may cause undesired operation.
The transmitter has been tested and com-
plies
with
FCC
and
DOC/MDC
rules.
Changes or modifications not expressly
approved by the party responsible for com-
pliance could void the user’s authority to
operate the device.
DOC: ISTC 1763K1313
FCC I.D.: CB2V67690
1-33