1999 Nissan Quest Owner's Manual - Page 63

Tethering to floor When installing a child restraint on the three-passenger bench seat in the third row position, first install the floor anchor bracket (available at an authorized NISSAN dealer) to the provided anchor point. Bracket part #88894-89900 To gain access to an anchor point, cut along the perforated floor carpeting of the cargo area. Installing the anchor bracket requires removing the bolt already installed at the anchor point and using a metric bolt of the dimensions listed below: Bolt diameter: 8.0 mm Bolt length: at least 1.18 in (30 mm) Thread pitch: 1.25 mm WARNING ● Bolts should be installed at all times to prevent the possibility of exhaust fumes entering the passenger compartment through the holes. ARS1200 INSTALLATION ON THREEPASSENGER BENCH SEAT IN THIRD ROW A child restraint with a top tether strap may be placed on the three-passenger bench seat when the bench seat is in the third row location. Once the child restraint is properly secured to the seat (see ''Front facing installation at second and third row outboard positions'' or ''Front facing installation at three-passenger bench seat center position'' earlier in this section), follow the directions to attach the tether strap to one of the anchor point locations. ● Child restraint anchor points are designed to withstand only those loads imposed by correctly fitted child restraints. Under no circumstances are they to be used for adult seat belts or harnesses. ● The parcel shelf (if so equipped) must be removed from the vehicle if installing a child restraint on the three-passenger bench seat that requires the use of a top tether strap that is anchored to the vehicle floor. Failure to remove the parcel shelf can increase the severity of injury to the child in an accident. Latch the tether strap hook onto the appropriate anchor bracket. The tether strap should be secured to the floor anchor bracket which provides the straightest installation. 1-56 Seats, restraints and supplemental air bag systems