2003 Nissan Murano Owner's Manual - Page 181
2003 Nissan Murano Manual
Page 181 highlights
¼ Use the correct jack up points; never use any other part of the vehicle for jack support. ¼ Never jack up the vehicle more than necessary. ¼ Never use blocks on or under the jack. ¼ Do not start or run engine while vehicle is on the jack, as it may cause the vehicle to move. This is especially true for vehicles with limited slip differential carriers. ¼ Do not allow passengers to stay in the vehicle while it is on the jack. WARNING ¼ Incorrect wheel nuts or improperly tightened wheel nuts can cause the wheel to become loose or come off. This could cause an accident. ¼ Do not use oil or grease on the wheel studs or nuts. This could cause the nuts to become loose. As soon as possible tighten the wheel nuts to the specified torque with a torque wrench. Wheel nut tightening torque: 80 ft-lb (108 N⋅m) Adjust tire pressure to the COLD pressure. COLD pressure: After vehicle has been parked for three hours or more or driven less than 1 mile (1.6 km). COLD tire pressures are shown on the tire placard affixed to the center pillar. SCE0039 Installing the spare tire 1. Clean any mud or dirt from the surface between the wheel and hub. 2. Carefully put the wheel on and tighten the wheel nuts finger tight. 3. With the wheel nut wrench, tighten wheel nuts alternately and evenly until they are tight. 4. Lower the vehicle slowly until the tire touches the ground. Then, with the wheel nut wrench, tighten the wheel nuts securely in the sequence as illustrated. 6-6 In case of emergency