2003 Nissan Murano Owner's Manual - Page 67

the meter comes on. The SECURITY indicator light glows for about 30 seconds and then blinks. The system is now activated. If, during this 30 second time period, the door is unlocked by the key or the keyfob, or the ignition key is turned to ACC or ON, the system will not activate. ¼ Even when the driver and/or passengers are in the vehicle, the system will activate with all doors and hood locked and ignition key off. Turn the ignition key to ACC to turn the system off. SIC2045 ¼ Opening the hood. How to stop alarm The alarm will stop only by unlocking a door with the key, or by pressing the UNLOCK button on keyfob. The alarm will not stop if the ignition switch is turned to ACC or ON. If the system does not operate as described above, have it checked by your NISSAN dealer. Vehicle security system operation The security system will give the following alarm: ¼ The headlights blink and the horn sounds intermittently. ¼ The alarm automatically turns off after approximately 1 minute. However, the alarm reactivates if the vehicle is tampered with again. The alarm can be shut off by unlocking a door with the key, or by pressing the UNLOCK button on the keyfob. The alarm is activated by: ¼ Opening the door without using the key or keyfob. ¼ Opening the back door without using the keyfob. NISSAN VEHICLE IMMOBILIZER SYSTEM The Nissan Vehicle Immobilizer System will not allow the engine to start without the use of the registered Nissan Vehicle Immobilizer System key. If the engine fails to start using the registered Nissan Vehicle Immobilizer System key, it may be due to interference caused by another Nissan Vehicle Immobilizer System key, an automated toll road device or automated payment device on the key ring. Restart the engine using the following procedures: 1. Leave the ignition switch in the ON position for approximately 5 seconds. 2. Turn the ignition switch to the OFF or LOCK position and wait approximately 10 seconds. How to activate the vehicle security system 1. Close all windows. The system can be activated even if the windows are open. 2. Remove the key from the ignition switch. 3. Close and lock all doors and hood. Lock all doors by pressing the LOCK button on the keyfob or using the key. When using the keyfob, the hazard indicators flash twice to indicate all doors are locked. 4. Confirm that the SECURITY indicator light in 2-16 Instruments and controls