2012 Subaru Impreza Owner's Manual - Page 171
2012 Subaru Impreza Manual
Page 171 highlights
Instruments and controls 3-7 NOTE . Even during the illumination after the driver 's door is opened, if the ignition switch is turned to the "ON" position, the combination meter will illuminate as usual. . If the doors are locked by the remote keyless entry system during the illumination after the driver 's door is opened, the illumination will be turned off. . Even while the illumination gradually turns off after the ignition switch is turned to the "LOCK" position, if the ignition switch is turned to the "ON" position, the combination meter illuminate as usual. To change the setting: 1. Turn the ignition switch to the "LOCK" or "Acc" position. 2. Press the trip knob to show " " or " " on the odometer and trip meter display. The display can be switched as shown in the following illustration by pressing the trip knob. & Speedometer The speedometer shows the vehicle speed. & Odometer/Trip meter *: " " or " ", and " " or " " cannot be displayed when the ignition switch is in the "ON" position. 3. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated 1) Trip knob This meter displays the odometer and two trip meters when the ignition switch is in the "LOCK", "Acc" or "ON" position. If you press the trip knob when the ignition switch is in the "LOCK" position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. - CONTINUED - NOTE The initial illumination setting of the meter/gauge needles of your vehicle has been set for activation " " at the time of shipment from the factory.