2012 Subaru Impreza Owner's Manual - Page 85

Seat, seatbelt and SRS airbags 1-9 1) 2) When not used (lowest position) When used (click position) To raise: Pull the head restraint up. To lower: Push the head restraint down while pressing the release button on the top of the seatback. To remove: While pressing the release button, pull out the head restraint. To install: Install the head restraint into the holes that are located on the top of the seatback until the head restraint locks. When the rear-center seating position is occupied, raise the head restraint to an appropriate position depending on your sitting height. When the rear center seating position is not occupied, lower the head restraint to improve rearward visibility. And make certain that the shoulder belts are fully visible. . Never allow passengers to ride on the folded rear seatback or in the cargo area or trunk. Doing so may result in serious injury or death. . Secure all objects and especially long items properly to prevent them from being thrown around inside the vehicle and causing serious injury during a sudden stop, a sudden steering maneuver or a rapid acceleration. ! 4-door models 1. Lower the head restraints. & Folding down the rear seatback WARNING 1) 2) Head restraint Release button . After returning the rear seatback to its original position, be certain to place all of the seatbelts and the tab attached to the seat cushion above the seat cushion. 2. Unlock the seatback by pulling the - CONTINUED -