2012 Subaru Impreza Owner's Manual - Page 302
2012 Subaru Impreza Manual
Page 302 highlights
7-12 Starting and operating start. ! To disengage the service mode Turn the ignition switch to the "ON" position, depress and hold the brake pedal, then press and release the " " button on the remote engine start transmitter three times. The system will pause for 1 second and flash the turn signal lights once indicating that the system has exited service mode. NOTE When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system. & Remote engine start transmitter programming and programmable feature option New transmitters can be programmed to the remote engine start system in the event that remote engine start transmitters are lost, stolen or damaged. The remote engine start system also has one programmable feature that can be adjusted for user preference. The remote engine start system can be programmed to either make an audible horn chirp upon remote start activation or not. Remote engine start transmitter programming and feature programming can be adjusted using the following procedure. 1. Open the driver 's door (the driver 's door must remain opened throughout the entire process). 2. Insert the key into the vehicle's ignition switch and turn to the "ON" position. 3. Locate the small black programming button behind the fuse box cover, on the driver 's side left under the dashboard panel. 4. Press and hold the black programming button for 10 to 15 seconds. The horn will honk and the turn signal lights will flash three times to indicate that the system has entered programming mode. At this point you can proceed to either step 5 or step 6. 5. To program a remote engine start transmitter: press and release the " " button on each transmitter. The horn will honk and the turn signal lights will flash one time to indicate a successful transmitter learn each time the " " button is pressed. You can program up to eight transmitters. 6. To toggle the Horn Confirmation chirps ON/OFF: depress and release the brake pedal to toggle the feature. The horn will chirp and the turn signal lights will flash one time to indicate Confirmation Horn Chirps are "OFF". The horn will honk and the turn signal lights will flash 2 times to indicate Confirmation Horn Chirps are "ON". Depressing the brake pedal repeatedly will toggle the feature ON or OFF each time. 7. To exit the remote engine start transmitter and feature programming mode, turn the ignition switch to the "LOCK" position, remove the key from the ignition switch and test operation of the remote engine start transmitter(s) and horn confirmation feature. & System maintenance ! Changing the batteries CAUTION . Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. . Be careful not to damage the printed circuit board in the remote engine start transmitter when replacing the battery. . Be careful not to allow children to touch the battery and any removed parts; children could swallow them. . There is a danger of explosion if