2008 Yamaha Motorsports RS Viking Professional Owners Manual - Page 30
2008 Yamaha Motorsports RS Viking Professional Manual
Page 30 highlights
Control functions Spring preload setting at the center shock absorber (spring preload adjusting ring position): Minimum (soft): 1 Standard: 1 Maximum (hard): 5 Spring preload setting at the rear shock absorber (spring preload adjusting ring position): Minimum (soft): 1 Standard: 2 Maximum (hard): 7 Adjusting the rear suspension extension spring preload ECS00270 1. Extension spring preload adjusting nut 2. Spring seat length Spring preload setting (spring seat length): Minimum (soft): 16 mm (0.63 in) Standard: 16 mm (0.63 in) Maximum (hard): 18 mm (0.71 in) Adjusting the rear suspension full rate ECS00750 CAUTION: The left and right extension spring preload must be set to the same setting. Uneven settings can cause poor handling and loss of stability. The extension spring preload can be adjusted by turning the extension spring preload adjusting nut. To increase the extension spring preload, turn the adjusting nut in. To decrease the extension spring preload, turn the adjusting nut out. CAUTION: G G Be sure to make this adjustment when there is no load (rider or cargo) on the snowmobile. Make sure that the full rate adjusting bolt ends are set at the same position on each side. NOTE: Never allow the full rate adjusting bolt to move while loosening or tightening the nut. 1. Loosen the nut 1/2 or 3/4 turn, while holding the adjusting bolt securely with a wrench so it does not move. 24