3Ware CBL-P-SATA Installation Guide - Page 33

Q3: The 3ware BIOS screen never appears., Q4: Some of the drives do not appear in the Disk Array - website

Get 3Ware CBL-P-SATA - Parallel-to-Serial Converter Storage Controller EIDE PDF manuals and user guides View all 3Ware CBL-P-SATA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

3ware Escalade ATA RAID Controller Installation Guide Q3: The 3ware BIOS screen never appears. The ATA RAID controller is not installed properly. Reinstall the hardware and reboot. There may also be a problem with the motherboard. Please check the Motherboard Compatibility List on the 3ware website at http://www.3ware.com/products/compatibility.asp to see if you motherboard has been tested by 3ware. Q4: Some of the drives do not appear in the Disk Array Configuration Utility's main display. Your drives are not connected properly to the ATA RAID controller. Check that both the power and ATA cables are connected properly and that the drives are all properly jumpered. To operate properly the ATA RAID controller requires that drives be set as Single (if available on your drive) or Master. 50 www.3ware.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
3ware Escalade ATA RAID Controller
Installation Guide
50
www.3ware.com
Q3: The 3ware BIOS screen never appears.
The ATA RAID controller is not installed properly. Reinstall the
hardware and reboot. There may also be a problem with the mother-
board. Please check the Motherboard Compatibility List on the
to see if you motherboard has been tested by 3ware.
Q4: Some of the drives do not appear in the Disk Array Config-
uration Utility’s main display.
Your drives are not connected properly to the ATA RAID controller.
Check that both the power and ATA cables are connected properly
and that the drives are all properly jumpered. To operate properly
the ATA RAID controller requires that drives be set as
Single
(if
available on your drive) or
Master
.