AIWA CX-NA303 Operating Instructions - Page 16
P--A-a
View all AIWA CX-NA303 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
i--r 1 11 II 9 1,2,3 1 2 2,3 r P--A-a 1 1 u, 1 Press CLOCK, then press II SET within 4 seconds. The unit can be turned off automatically at a specified time. Use the remote control. 1 Press SLEEP while pressing SHIFT. When using the remote control Press CLOCK while pressing SHIFT, then press II SET !Mt!lin 4 seconds. 2 Press + DOWN or > UP to designate the hour, then press II SET. The hour stops flashing and the minute starts flashing. 3 Press - DOWN or - UP to designate the minute, then press II SET. The minute stops flashing on the display and the clock starts from 00 seconds. To display the current time Press CLOCK. The time is displayed for 4 seconds. However, the time cannot be displayed during recording. To switch to the 24-hour standard Press the CLOCK and then press s within 4 seconds. Repeat the same procedure to restore the 12-hour standard. If the clock display flashes This is caused by a power interruption. The current time needs to be reset. If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset. MULTI JOG is also available instead of U and W. 2 Within 4 seconds, press < or W to specify the time until the power is turned off. Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps. Specified time I To check the time remaining until the power is turned off Press SLEEP once while pressing SHIFT. The remaining time is displayed for 4 seconds. To cancel the sleep timer Press SLEEP twice while pressing SHIFT so that "SLEEP OFF" appears on the display. * MULTI JOG is also available instead of U and W. 15 ENGLISH