Ariens Deluxe Track 28 Owners Manual - Page 28
Manual Discharge, Chute Deflector, Discharge Chute, 019, 020, 022, 023, Speed Selector, Adjustment
View all Ariens Deluxe Track 28 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
If chute does not rotate freely: Tighten the cable by loosening the forward adjustment nut, and then tightening the rear adjustment nut against the bracket until all cable slack is removed (Figure 30). MANUAL DISCHARGE CHUTE DEFLECTOR (921019) (Figure 31) Deflector must stay in selected position while blowing snow. To adjust, loosen then retighten hardware to desired deflection drag force (Figure 31). Adjusting Hardware Discharge Chute Deflector DISCHARGE CHUTE (921013, 019, 020, 022, 023) (Figure 32) If discharge chute does not stay in position while operating, tighten nut on carriage bolt at pivot point to increase tension on spring. 1 2 Discharge Chute Figure 31 OS7176 OS7177 1. Spring 2. Nut Figure 32 1 2 SPEED SELECTOR ADJUSTMENT (Figure 33) To adjust: 1. Disconnect adjustment pivot pin from speed selector lever by removing hairpin. 2. Place the speed selector on the dash in the fastest forward speed position. 3. Turn the speed selector lever straight down towards the ground as far as it will go. 4. Thread the adjustment pivot pin along the shift rod until it aligns with the mating hole on the speed selector lever. Insert the pivot pin into hole. 5. Secure adjustment pivot pin with hairpin. 6. Make sure the speed selector shifts into each speed position. 7. Check forward and reverse speeds: a. Start unit. b. Shift speed selector into the first forward speed. GB - 28