Asus A7S-VM A7S-VM User Manual - Page 38

3. HARDWARE SETUP The following 20-pin PANEL illustration is for items 19-24. SMI Lead Message LED Speaker Connector MSGLED+ MSGLEDExtSMI# Ground +5V Ground Speaker PWRBTN Ground IDELED+ IDELEDPWRLED+ PWRLEDPWRLEDB- Reset Ground 3. H/W SETUP Connectors ATX Power Switch* Reset SW IDELED Power LED A7S-VM * Requires an ATX power supply. A7S-VM System Panel Connectors 19) System Power LED Lead (3-1 pin PWR.LED) This 3-1 pin connector connects to the system power LED. The LED lights up when you turn on the system power, and blinks when the system is in sleep or soft-off mode. 20) System Warning Speaker Lead (4-pin SPEAKER) This 4-pin connector connects to the case-mounted speaker and allows you to hear system beeps and warnings. 21) System Message LED Lead (2-pin MSG.LED) This 2-pin connector is for the system message LED that indicates receipt of messages from a fax/modem. The normal status for this LED is ON, when there is no incoming data signal. The LED blinks when data is received. The system message LED feature requires an ACPI OS and driver support. 22) System Management Interrupt Lead (2-pin SMI) This 2-pin connector allows you to manually place the system into a suspend mode, or "Green" mode, where system activity is instantly decreased to save power and to expand the life of certain system components. Attach the casemounted suspend switch this 2-pin connector. 23) ATX Power Switch / Soft-Off Switch Lead (2-pin PWR.SW) The system power is controlled by a momentary switch attached to this connector. Pressing the button switches the system between ON and SLEEP, or ON and SOFT OFF, depending on the BIOS or OS settings. Pressing the button while in the ON mode for more than 4 seconds turns the system off. 24) Reset Switch Lead (2-pin RESET) This 2-pin connector connects to the case-mounted reset switch for rebooting the system without turning off the power switch. This is a preferred method. 38 ASUS A7S-VM User's Manual