Asus AP200 Hardware Reference - Page 23

IV. Hardware Setup CD-ROM Drive Mounting and Connections The CD-ROM disk drive mounts only in the 5.25" device cage and requires signal and power connections. The red stripe of the signal and power cables should face each other. CD Audio Output CD-ROM Drive Connections NOTE: A CD-ROM audio cable is also provided in case you install an audio card. The only function of the audio cable is to allow you to direct the CD audio out signal to your audio card. Data signals travel through the IDE cable. Red Stripe of the Signal Cable Red Stripe of the Power Cable 4-5. Hard Disk Drives Hard Disk Drive Carrier Plate A carrier plate on top of the power supply is used to hold an one-inch hard disk drive. Screw the underside of the hard disk drive on the bottom of the carrier plate as shown. IV. HW Setup Hard Disk Drives Hard Disk Drive Mounted on the Carrier Plate The carrier slides into the chassis in this direction. The handle faces upward. AP200 Hardware Reference Guide 23