Asus P4G8X P4G8X User Manual - Page 47
MB/s Ultra ATA/133.
View all Asus P4G8X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
4. Serial ATA connectors (7-pin SATA1, SATA1) These next generation connectors support the thin Serial ATA cables for Serial ATA hard disks. The current Serial ATA interface allows up to 150 MB/s data transfer rate, faster than the standard parallel ATA with 133 MB/s (Ultra ATA/133). P4G8X ® P4G8X SATA Connectors GND RSATA_RXP2 RSATA_RXN2 GND RSATA_TXN2 RSATA_TXP2 GND GND RSATA_TXP1 RSATA_TXN1 GND RSATA_RXN1 RSATA_RXP1 GND SATA2 SATA1 If you wish to create a RAID set, make sure that you have connected the SATA cable and installed Serial ATA devices. You cannot enter the SATARaid™ utility and SATA BIOS setup during POST if there are no connected Serial ATA devices. 5. Chassis intrusion connector (4-1 pin CHASSIS) This lead is for a chassis designed with intrusion detection feature. This requires an external detection mechanism such as a chassis intrusion sensor or microswitch. When you remove any chassis component, the sensor triggers and sends a high-level signal to this lead to record a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. If you wish to use the chassis intrusion detection feature, remove the jumper cap from the pins. CHASSIS +5VSB_MB Chassis Signal GND P4G8X ® P4G8X Chassis Alarm Lead (Default) ASUS P4G8X series motherboard user guide 2-21