Asus P4PE P4PE User Manual - Page 46
Hardware information, RAID ATA/133/100/66/33 connector 40-1 pin PRI_RAID1 - hdd
View all Asus P4PE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
4. RAID ATA/133/100/66/33 connector (40-1 pin PRI_RAID1) (on RAID models only) This connector supports either RAID 0 or RAID 1 configuration through the onboard Promise PDC20376 controller. You can use the RAID feature to set up a disk array configuration and to support additional IDE devices. ® P4PE PRI_RAID1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1. P4PE RAID IDE Connectors PIN 1 Important notes on the RAID feature: • By default, the drive that you connect to the PRI_RAID1 connector follow the ATA133/100/66/33 protocol as an independent drive, not as a disk array. • The PRI_RAID1 connector supports only one HDD set to Master mode. An HDD set to Slave mode does not work. • For RAID 0 configuration, you may use any two of the Parallel ATA and Serial ATA connectors, or all three connectors. • For RAID 1 configuration, you may use any two of the Parallel ATA and Serial ATA connectors. • The RAID/SATA controller chipset does not support ATAPI devices such as CD-ROMs, DVD-ROMs, etc. 2-20 Chapter 2: Hardware information