Autodesk CIVIL3D Tutorial - Page 270

9 Click Insert Property. Select Length. 10 In the Design Check field, enter >=310,1) (including the closing parenthesis). The following formula should be displayed in the Design Check field: IF({Design Speed}>=50,Length>=310,1) NOTE In this formula, the ending numeral 1 specifies that the preceding formula is acceptable. If the entity parameters do not meet the values specified in the formula, a violation is issued. 11 Click OK. 12 In Toolspace, on the Settings tab, expand the Alignment ➤ Design Checks ➤ Line collection. The design check you created is displayed in the Line collection. Add a design check to a design check set 1 In Toolspace, on the Settings tab, expand the Alignment ➤ Design Checks ➤ Design Check Sets collection. 2 Right-click the 50kmh Roadway Length Checks design check set. Click Edit. This is the design check set that is applied to the alignment in the current drawing. Notice that the design checks that are in the selected design check set are displayed in the Toolspace list view. TIP To create a new, empty design check set, right-click the Design Check Sets collection and click New. 3 In the Alignment Design Check Set dialog box, click the Design Checks tab. The table on this tab lists the design checks that are currently in the design check set. The drop-down lists above the table allow you to add design checks to the set. 4 In the Type list, select Line. 5 In the Line Checks list, select L>=310m @ 50km/h, which is the design check that you created in the previous procedure. Click Add. Click OK. 258 | Chapter 8 Alignments Tutorials