Autodesk CIVIL3D Tutorial - Page 654

5 In the Structure Rule Set dialog box, click Edit Current Selection. 6 In the Structure Rule Set dialog box, click the Rules tab. The selected design rules specify that the structure has a maximum drop value of 3.000' and maximum pipe diameter or width of 4.000'. You can modify these values, or click Add Rule to add another rule. 7 Click Cancel twice. 8 On the Pipes tab, expand Standard then Concrete Pipe. Click 24 Inch Concrete Pipe. 9 In the Rules cell, click . In the Pipe Rules Set dialog box, click Edit Current Selection. In the Pipe Rule Set dialog box, click the Rules tab. The selected design rules allow pipes of a maximum length of 200 feet, which is typical of a pipe layout that travels through open terrain. 10 Click OK four times. To continue this tutorial, go to Exercise 3: Adding a Branch to a Pipe Network (page 642). Exercise 3: Adding a Branch to a Pipe Network In this exercise, you will add a branch to the existing pipe network layout and use the part status to review and edit the layout. In addition to indicator icons that indicate where parts can be connected, you will see icons when the pipe or structure you are adding to the layout will break an existing pipe. The pipes created by the break are automatically connected to the new structure or pipe. For more information, see the AutoCAD Civil 3D Help topic Adding a Part to a Pipe Network. This exercise continues from Exercise 2: Changing the Surface, Alignment, and Rules Configuration (page 640). 642 | Chapter 17 Pipe Network Tutorials