Beko WDIK752451 Owners Manual - Page 11
Installation
View all Beko WDIK752451 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3 Installation To make the product ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out. B DANGER! • Make sure that the installation and electrical connections of the product are performed by competent persons. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised persons. DANGER! • Your product is too heavy for one person to carry. A CAUTION! • Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. 3.1 Appropriate installation location • Place the product on a solid and level floor. Do not place it onto a carpet with high pile or other similar surfaces. • Do not place the product close to the edge if the floor contains steps. Do not also place the product on a platform. • Do not place the product on the power cable. • Do not install the product in environments where the temperature falls below 0 ºC.(See. Warnings for Drying) • Leaving a gap at the sides of the machine is suggested to reduce vibration and noise • In the area where this product is installed, there must not be a lockable, sliding or hinged door that will restrict the full opening of loading door. • Operate the product in a well ventilated and dust free environment. • Do not place heat sources such as Hobs, Irons, Ovens, etc. on the washing machine and do not use them on the product 3.2 Removing packaging reinforcement A PRECAUTION! • Preparation of the location and electrical, tap water and waste water installations at the place of installation is under customer's responsibility. • Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement attached to the ribbon. B DANGER! • Your product is heavy. Remove packaging reinforcement as displayed in the figure. • Be careful not to get your hand caught under the machine during this procedure. 11 / EN Washer-Dryer / User Manual