Beko WDIK752451 Owners Manual - Page 42

There is detergent left on the laundry. • Machine might have been overloaded. >>> Do not overload the machine. • Wrong programme and temperature might have been selected. >>> Select the right programme and temperature for the laundry to be washed. • Wrong detergent might have been used. >>> Select a proper detergent for the laundry to be washed. Too much foam forms in the machine. (**) • Improper detergents for the washing machine might have been used. >>> Use detergents suitable for washing machine. • Excessive amount of detergent might have been used. >>> Use only sufficient amount of detergent. • Detergent might have been stored under inappropriate conditions. >>> Keep the detergent in a closed and dry area. Do not store it in excessively hot places. • Meshed laundry such as tulles might foam too much due to their texture. >>> Use less detergent for these types of fabrics. • Detergent might have been put in the wrong compartment. >>> Put the detergent in the correct compartment. • Softener is taken early. >>> There might be a problem with the valves or the detergent drawer. Call the Authorised Service Agent. Foam is overflowing from the detergent drawer. • Excessive amount of detergent might have been used. >>>>Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of the detergent drawer. • Put detergent into the machine suitable for the programmes and maximum loads indicated in the "Programme and consumption table". If you use additional chemicals (stain removers, bleaches and etc), reduce the amount of detergent. Laundry remains wet at the end of the programme. (*) • Excessive foam might have formed due to use of too much detergent, and the automatic foam absorption system might have been activated. >>> Use the recommended amount of detergent. Drying lasts too long. • Machine might have been overloaded. >>> Do not overload the machine. • Spinning might not be sufficient for laundry. >>> Select a higher spin speed in the washing step of the Washer-Dryer. • Tap might be turned off. >>> Turn on the taps. Laundry comes off wet after the drying step. • The programme selected might not be suitable for the type of laundry. >>>Check the care labels on garments and select a programme accordingly, or select timed programmes additionally. • Machine might have been overloaded. >>> Do not overload the machine. • Spinning might not be sufficient for laundry. >>> Select a higher spin speed in the washing step of the Washer-Dryer. Machine does not start or programme cannot be started. • Power cable might be unplugged. >>> Make sure that the power cable is plugged in. • Programme might not be set, or the Start/Pause/ Cancel button might not be pressed. >>> Make sure the programme is set and the machine is not in Stand-by mode. • Child lock might be enabled. >>> Disable Child Lock. Laundry shrinks, fades, tarnishes or gets damaged. • The programme selected might not be suitable for the type of laundry. >>>Check the care labels on garments and select a programme accordingly, or select timed programmes additionally. You should not dry laundry that is not suitable for drying. Machine does not dry. • Laundry might not be dried or the drying step might not be enabled. >>> Check if the drying function is selected after the selected washing programme. Loading door cannot be opened. • The door of your machine might not be opening due to safety reasons. >>>If the door locked indicator is active on the display after the drying step, the machine will keep the door locked for your safety until it cools down. • The loading door will not open if there is no power. >>> To open the loading door, open the pump filter cap and pull down the emergency handle positioned at the rear side of the said cap. See "Loading door lock" (*) Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to the machine and to its surrounding environment. Readjust the laundry and perform spinning again. (**) The drum might not have been cleaned regularly. >>> Clean the drum regularly. See 6.2 A CAUTION! • If you cannot eliminate the problem although you follow the instructions in this section, consult your dealer or the Authorised Service Agent. Never try to repair a nonfunctional product yourself. A WARNING! • Check the HomeWhiz section for the relevant troubleshooting information. 42 / EN Washer-Dryer / User Manual