Beko WMC126 User Manual - Page 28

6 Maintenance and cleaning Service life of the product extends and frequently faced problems decrease if cleaned at regular intervals. Cleaning the detergent drawer Clean the detergent drawer at regular as shown below in order to prevent accumulation of powder detergent in time. (compartment nr. II). If the anti-limescale is in tablet form, put only one tablet into compartment nr. II. Dry the inside of the bellow with a clean piece of cloth after the programme has come to an end. every 2 months. Use an anti-limescale suitable for the washing machines. foreign substance is left in the drum. in the softener compartment and pull towards you until the compartment is removed from the machine. If more than normal amount of water and softener mixture starts to gather in the softener compartment, the siphon must be cleaned. 2. Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear protective gloves or use an appropriate brush to avoid touching of the residues in the drawer with your skin when cleaning. 3. Insert the drawer back into its place after cleaning and make sure that it is seated well. Cleaning the loading door and the drum dirt may accumulate in your machine in time and may cause unpleasant odours and washing complaints. To avoid this, use the Drum Cleaning programme. If your machine is not featured with Drum Before starting the programme, put max. 100 g of anti-limescale powder into the main wash detergent compartment If the holes on the bellow shown in the figure is blocked, open the holes using a toothpick. Foreign metal substances in your machine will cause rust stains. Clean the stains on the drum surface by using cleaning agents for stainless steel. Never use steel wool or wire wool. Cleaning the body and control panel Wipe the body of the machine with soapy water or non-corrosive mild gel detergents as necessary, and dry with a soft cloth. Use only a soft and damp cloth to clean the control panel. Never use sponge or scrub materials. These will damage the painted and plastic surfaces. Cleaning the water intake filters There is a filter at the end of each water intake valve at the rear of the machine and also at the end of each water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in the water to enter the washing machine. Filters should be 28 EN