Beko WMC126 User Manual - Page 8

3 Installation To make the product ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate before installation. If they are not ,call a qualified technician and plumber to have any necessary arrangements carried out. Removing packaging reinforcement After removing transportation locks (see below) tilt the machine backwards and remove the packaging reinforcement attached to the ribbon. Preparation of the location and electrical, tap water and waste water installations at the place of installation is the customer's responsibility. Installation and electrical connections of the product must be carried out by a competent person. Manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised persons. Prior to installation, visually check if the product has any defects on it. If so, do not have it installed. Damaged products cause risks for your safety. Make sure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed while pushing the product into its place after installation or cleaning procedures. Appropriate installation location Removing the transportation locks bolts before operating the washing machine, otherwise, the product will be damaged. until they rotate freely (C). Do not place it on a long pile rug or similar surfaces. and the dryer -with full load- when they are placed on top of each other Place the product on a solid and flat floor that has sufficient load carrying capacity! power cable. turning them gently. where temperature may fall below from the edges of other furniture. 8 EN