Beretta Stampede Old West Beretta Stampede User Manual - Page 26

Loading

Get Beretta Stampede Old West PDF manuals and user guides View all Beretta Stampede Old West manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

LOADING To load your Beretta Stampede single-action revolver, follow the steps below: ! WARNING: Be certain that the revolver is pointed in a SAFE direction and your other hand is away from the muzzle. ! WARNING: Do not place your finger on the trigger or inside the trigger guard while loading. ! WARNING: Be sure that you have the correct cartridges for your revolver. ! WARNING: Be sure that the obstruction check has been completed prior to loading. 1. With the firearm pointed in a SAFE direction and your finger OFF the trigger and outside the trigger guard, pull the hammer rearward to the half-cock position, allowing the cylinder to rotate. (Fig. 7) 2. Locate the loading gate on the right side of the frame, rear of the cylinder. (Fig. 1-L) 3. Open the loading gate and align an empty chamber with the loading gate. (Fig. 11) 4. Insert a cartridge into the empty chamber. (Fig. 1-I) 5. Carefully rotate the cylinder clockwise (as viewed from the rear) to the next empty chamber and insert a cartridge. Repeat step five until all chambers are loaded. Close the loading gate. 6. With the gun pointed in a SAFE direction, pull the hammer slightly rearward with your thumb and gently ease the hammer forward to the fully lowered position as described above. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
26
LOADING
To load your Beretta Stampede single-action revolver, follow the
steps below:
WARNING:
Be certain that the revolver is pointed in a SAFE
direction and your other hand is away from the muzzle.
WARNING:
Do not place your finger on the trigger or inside the
trigger guard while loading.
WARNING:
Be sure that you have the correct cartridges for your
revolver.
WARNING:
Be sure that the obstruction check has been
completed prior to loading.
1. With the firearm pointed in a SAFE direction and your finger
OFF the trigger and outside the trigger guard, pull the hammer
rearward to the half-cock position, allowing the cylinder to
rotate.
(Fig. 7)
2. Locate the loading gate on the right side of the frame, rear of
the cylinder.
(Fig. 1-L)
3. Open the loading gate and align an empty chamber with the
loading gate.
(Fig. 11)
4. Insert a cartridge into the empty chamber.
(Fig. 1-I)
5. Carefully rotate the cylinder clockwise (as viewed from the
rear) to the next empty chamber and insert a cartridge.
Repeat step five until all chambers are loaded.
Close the loading gate.
6. With the gun pointed in a SAFE direction, pull the hammer
slightly rearward with your thumb and gently ease the hammer
forward to the fully lowered position as described above.
!
!
!
!