Bernina 530 Manual - Page 23
Hemmer, Gathering
View all Bernina 530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Hemmer Hem width approx. lint") Attach the hemmer in place of the ordinary presser foot, raising the presser foot bar for the purpose. Fig. El Fold the edge of the material over to the desired hem width and pass the fabric into the spiraltype guide tongue of the raised hemmer as far as the needle, then lower the hemmer. When sewing, lightly guide the prefolded edge (Fig. 21). If too much fabric enters the hemmer, the seam will become bulgy and uneven; if too little the hem will not be folded in sufficiently. 40 (Available as Extras) Gathering foot Fitt. 21a Put the material to be gathered under the gathering foot, that is to say not in the transverse slot. Lower the gathering foot by means of the presser foot lever and insert the piece of material, which must remain quite flat, in the transverse slot as far as it will go. To increase the amount of gathering or gauging on the bottom material hold the top material back - the more it is held back the greater the amount of gathering. ,ht 4 If only one layer of material has to be gathered place the material beneath the gathering foot and lower it. The material is gathered more or less as the length of stitch is made greater or smaller. 41