Bernina Activa 210 User Guide - Page 10
Winding the bobbin
View all Bernina Activa 210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Setting up the sewing computer Winding the bobbin Winding the bobbin • turn power switch on • place empty bobbin on spindle • following the direction of the arrow take thread through the rear guide and round the pre-tension stud • wind the thread two to three times around the empty bobbin and cut off any excess thread on the thread cutter • press the engaging lever against the bobbin • press the foot control • the motor will stop automatically when the bobbin is full • remove the bobbin Thread cutter • cut the thread on the thread cutter Note: When winding the bobbin on the vertical spool holder (p. 13), it may be necessary to adjust the speed. 032622.50.04_0701_a210_EN
Setting up the sewing computer
10
Winding the bobbin
•
turn power switch on
•
place empty bobbin on
spindle
•
following the direction of the arrow take thread through the rear
guide and round the pre-tension stud
•
wind the thread two to three times around the empty bobbin
and cut off any excess thread on the thread cutter
•
press the engaging lever against the bobbin
•
press the foot control
•
the motor will stop automatically when the bobbin is full
•
remove the bobbin
Thread cutter
•
cut the thread on the thread
cutter
Winding the bobbin
Note:
When winding the bobbin
on the vertical spool holder
(p. 13), it may be necessary to
adjust the speed.
032622.50.04_0701_a210_EN