Binatone iDECT Freedom User Manual - Page 27

7.4.6 PBX ACCESS If you use the phone on a PBX that needs an access digit to get an external line, a single digit can be set to dial automatically before any Phonebook or Calls List number. 1. Press and to select BS SETTINGS. 2. Press and to select PBX ACCESS. 3. Press to show CODE, then enter your access digit (1-0) and press to confirm it and activate the feature. Note: Press to delete any access digit, and deactivate the feature. 7.5 Registration IMPORTANT: When you purchase your phone system, all handsets and the headset are already registered to your base, so you do not need to register them. Handset registration is only necessary when you buy extra handset or if a handset has become faulty. You can register additional handsets to have up to five handsets per base unit, with each handset's number (1 to 5) shown on its display. (Note: each handset can only be registered to one base.) 7.5.1 To register a new handset to your base: 1. Press and hold on the base station for more than five seconds, to put the base station into registration mode. It will stay in registration mode for about 1 minute, so the following handset sequence must be completed within this time. 2. Press and to select REGISTRATION. 3. Press to display PIN?------. 4. Enter the 4-digit system PIN(default0000). 5. Press to confirm, and the display will show PLEASE WAIT. If the handset registration is successful, you will hear a confirmation tone and the will stop flashing. The handset will automatically be allocated the next available handset number. This handset number is shown in the handset display in standby mode. If the handset registration is unsuccessful, the will still flash. 25