Bosch KBD-DIGITAL User Manual - Page 16

12 en | Controlling Allegiant Series Video Switchers IntuiKey Keyboard Load Sequence Enables the loading of a previously programmed sequence. - Press the Load Sequence softkey. The status display shows the following: - - - Sequence? Allegiant Hold Sequence Figure 2.8 Load Sequence Display Sequence programming is displayed on the controlled monitor screen. - Enter the sequence number, then press ENTER. - To unload a sequence, stop the sequence (if necessary), press the Load Sequence softkey, then press ENTER. - Use CLR to clear an incorrectly entered number. Stops a running sequence. Previous Sequence Sets the sequence direction to run in reverse. If the sequence is Step already running in reverse, pressing this button executes the previous sequence step immediately. Holding the key causes the sequence to run in fast reverse mode, at approximately two steps User Log-off per second. Used to LOG OFF the Allegiant Switcher. - Press the User Log OFF softkey. - The softkey display shows the following: Allegiant User Log OFF Press: [Enter] to log off [Clr] to Exit F.01U.127.291 | 1.93 | 2009.03 Figure 2.9 User Log-off Menu - Press CLR to clear the pending log-off. Press ENTER to complete the log-off process. The softkey display reverts to displaying only USER LOG ON, and the status display changes back to the default mode (i.e. camera and monitor numbers replaced with dashes). This mode times out in approximately two seconds and reverts to the previous menu. User Manual Bosch Security System, Inc.