Bosch KBD-DIGITAL User Manual - Page 21

IntuiKey Keyboard Controlling Allegiant Series Video Switchers | en 17 2.4 Allegiant Error Messages Error Error 01 Error 02 Error 03 Error 04 Error 05 Error 06 Error 10 Error 11 Error 15 Error 20 Error 21 Error 22 Error 23 Error 24 Error 25 Error 50 Error 52 Name Invalid Camera Request Invalid Monitor Request Remote Device Locked by User# Monitor Locked by User# Remote Device Access Restricted Monitor Access Restricted Access Denied Access Denied Invalid User Function Acknowledge Denied Incorrect Acknowledge Acknowledge Disabled Camera not in Alarm Keyboard Not Enabled for Acknowledge Alarm Switcher Running Sequence Not Available Sequence Request Description The camera number entered from the keyboard does not exist. If using the optional LTC 8059/00 Master Control Software or the LTC 8850/00 Graphical User Interface Software, ensure that the number exists in the Camera Identification table. Download the table to be sure. The monitor number entered from the keyboard does not exist. The remote device requested cannot be controlled, because it is locked by a user with equal or higher priority. Check with the other users or request that a higher priority user unlock the remote device. The monitor requested cannot be accessed, because it is locked by a user with equal or higher priority. Check with the other users or request that a higher priority user unlock the monitor. Remote locked out by Remote Lock Out table. Monitor locked out by Monitor Lock Out table. A function was requested for which the user priority is too low. Only a Priority 2 user or a supervisor with Priority 1 may access this function. A function was requested for which the user priority is too low. Only a supervisor with Priority 1 may access this function. The function number requested from the keyboard is invalid. Refer to the User Function table for a listing of valid user function numbers. The ACKNOWLEDGE button was pressed by a user without the authority to acknowledge alarms. In order to properly acknowledge an alarm event, the keyboard must be switched to a monitor that is displaying the alarms. Alarms on this monitor cannot be acknowledged, because that capability has been disabled by the system programmer. The camera displayed on the monitor is not an alarm video; only alarm-generated video can be acknowledged. This keyboard may not acknowledge alarm video on this monitor; it has been disabled by the system programmer. Alarm video may only be acknowledged if the alarm switcher is not running; press HOLD to stop the switcher. The user attempted to load a switcher sequence that does not exist. This is a good way to determine, from the keyboard, which sequence numbers are unused when desiring to add one. A request was made to load an ABSOLUTE type sequence, without the keyboard being on one of the monitors in that sequence. Because inadvertent loading of monitors should be avoided, the user is required to switch his keyboard to one of the monitors used by the sequence. The PROGRAM mode may be used to review which monitors are used in the sequence. A request was made to load a RELATIVE type sequence on a monitor number that is too high; the monitors used by the sequence would extend past the highest monitor. Try switching to a lower monitor number before loading the sequence. Bosch Security System, Inc. User Manual F.01U.127.291 | 1.93 | 2009.03