Bowflex Ultimate 2 Owners Manual - Page 37

Wide Pulldowns, Narrow Pulldowns with Hand Grips - ab attachment

Page 37 highlights

35 Back Exercises Wide Pulldowns - Shoulder Adduction (with elbow flexion) Muscles worked: Latissimus Dorsi; Teres Major; Rear Deltoids; Biceps Bench Position: Flat Bench Forward Accessory: Bent Lat Bar Pulleys: Lat Tower START FINISH Success Tips • Keep knees bent and feet flat on floor. • To determine the appropriate grip width for you, hold your arms straight out to your sides at shoulder height. Bend your elbows approximately 90°. Hands should be no wider apart than your elbows (beginners may narrow their grip to increase comfort). • Keep your spine aligned, abs tight and a slight arch in your lower back. START • Grasp the Bent Lat Bar using the wide grip determined by following the directions in the Success Tips, then sit on the bench, facing the Power Rod® units. • Position your thighs directly under the Lat Tower pulleys. Sit upright. • Keep your arms extended and straight. ACTION • Initiate movement by pulling shoulder blades together while simultaneously drawing elbows down and inward. • Bent Lat Bar may not touch your chest. At the end of the motion, arms should be near your sides, shoulder blades fully depressed. • Keep forearms facing upward. • Slowly return to Start position. Narrow Pulldowns with Hand Grips - Shoulder Extension (with elbow flexion) Muscles worked: Latissimus Dorsi; Teres Major; Rear Deltoids; Biceps Bench Position: Flat Bench Forward Accessory: Hand Grips Pulleys: Lat Tower START FINISH Success Tips • Keep your chest lifted, abs tight, and a very slight arch in your lower back. • Keep knees bent and feet flat on floor. • Keep the lats tightened throughout the entire motion. START • Attach a Hand Grip to each cable on the Lat Tower Pulleys. • Straddle the bench facing the Power Rod® units, grasp a Hand Grip in each hand, palms facing each other and sit down on the bench. • Position your thighs directly under the Lat Tower pulleys. Sit upright. ACTION • Keep hands at shoulder width, arms straight. Initiate movement by pulling your shoulder blades down and together while simultaneously bending your elbows, drawing them down and inward towards your sides. • At the end of the motion, arms should be near your sides, shoulder blades depressed, forearms facing upward. • Slowly return to Start position.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88

35
Back Exercises
Wide Pulldowns
— Shoulder Adduction (with elbow flexion)
START
ACTION
START
• Grasp the Bent Lat Bar
using the wide grip
determined by following
the directions in the
Success Tips, then sit on
the bench, facing the Power
Rod
®
units.
• Position your thighs directly
under the Lat Tower pulleys.
Sit upright.
• Keep your arms extended
and straight.
• Initiate movement by pulling
shoulder blades together
while simultaneously
drawing elbows down and
inward.
• Bent Lat Bar may not touch
your chest. At the end of the
motion, arms should be near
your sides, shoulder blades
fully depressed.
• Keep forearms facing
upward.
• Slowly return to Start
position.
FINISH
Muscles worked:
Latissimus Dorsi;Teres Major;
Rear Deltoids; Biceps
Bench Position:
Flat Bench Forward
Accessory:
Bent Lat Bar
Pulleys:
Lat Tower
Success Tips
• Keep knees bent and feet flat
on floor.
• To determine the appropriate
grip width for you, hold your
arms straight out to your sides at
shoulder height. Bend your elbows
approximately 90°. Hands should
be no wider apart than your
elbows (beginners may narrow
their grip to increase comfort).
• Keep your spine aligned, abs tight
and a slight arch in your lower
back.
Narrow Pulldowns with Hand Grips
— Shoulder Extension (with elbow flexion)
START
ACTION
START
• Attach a Hand Grip to each
cable on the Lat Tower
Pulleys.
• Straddle the bench facing
the Power Rod
®
units, grasp
a Hand Grip in each hand,
palms facing each other
and sit down on the bench.
• Position your thighs directly
under the Lat Tower pulleys.
Sit upright.
• Keep hands at shoulder
width, arms straight. Initiate
movement by pulling your
shoulder blades down and
together while simultaneously
bending your elbows, drawing
them down and inward
towards your sides.
• At the end of the motion, arms
should be near your sides,
shoulder blades depressed,
forearms facing upward.
• Slowly return to Start
position.
FINISH
Muscles worked:
Latissimus Dorsi;Teres Major;
Rear Deltoids; Biceps
Bench Position:
Flat Bench Forward
Accessory:
Hand Grips
Pulleys:
Lat Tower
Success Tips
• Keep your chest lifted, abs tight,
and a very slight arch in your
lower back.
• Keep knees bent and feet flat
on floor.
• Keep the lats tightened
throughout the entire motion.