Brother International BES-941BC Instruction Manual - English - Page 169
Problem, Check Point, Check these points once again, Refer to Replacing the Lower Shaft Module.
View all Brother International BES-941BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 169 highlights
Check these points once again Chapter 10 Troubleshooting Problem Machine operation abnormal Check Point • Is the XY carriage belt damaged? • Are any set screws for the XY pulley loosened? • Are any set screws for the coupling of the XY pulse motor loosened? Upper shaft locks at a certain point in one cycle • Is the thread take-up stopped due to interference with the upper case cover? [Adjustment] Thread take-up Upper case cover Bolt Needle case Thread take-up operating lever Loosen the hexagon socket head cap screw of the thread takeup operating lever and adjust the take-up movable range. Tighten it securely afterwards. • Are the needle bar clamp and the top dead center stopper positioned correctly? Error display • Check the rotary hook of a machine head whose MENDING lamp (green) is blinking to see if the thread is caught. [Adjustment] 1.Take out the thread tangled in the rotary hook race so that the rotary hook can be rotated forcibly by manual operation. 2.Check that the machine pulley is set to 100˚ of the scale, and press the END switch. [Measures] 1.If the thread end is left too long or stitching is left loosened before starting embroidering, the thread is caught in the machine and operation stops. 2.When starting embroidering, hook the thread end on the spring or hold it with a hand. 3.Leave thread of about 60 ~ 70 mm from the needle hole when starting embroidering. • Is thread tangled in the rotary hook? Clean the rotary hook. • Conduct BC sensor test of the PC test mode. If there is any failure, replace the lower shaft with a new one. (Refer to "Replacing the Lower Shaft Module".) Upper shaft pulley does not turn. • Is the presser foot lifted at a retract position when the power is turned on? Lower the presser foot for the four machine heads using the lever. Stitches cannot be made. • Is the needle attached properly? • Is the timing of the needle and rotary hook correct? BES-941BC • BES-1241BC 167