Brother International BES-941BC Instruction Manual - English - Page 29
After adjustment is finished, top surface will become 1 mm lower than the bed top surface.
View all Brother International BES-941BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 1 Preparation of Embroidery Machine o Pin i t (A) y (A) u q Lower by 1 mm e 4. Mount four drilling bolts i, spring washers !,0 flat washaers !1 each on the rear of F table R t, M y, and L u. 5. Mount four thumb bolts on the steel pipe below the front leg. 6. Insert the pins attached to the rear of the F table R t, M y, and L u into the cover o on the leg. Adjust the height of the F table guide U q and the F table support F e so that the table top surface will become 1 mm lower than the bed top surface. After adjustment is finished, tighten each bolt securely. 7. Mount a drilling bolt i, a spring washer !,0 and a flat washer !1 in section (A) of F tables R t and L u. BES-941BC • BES-1241BC 27
Chapter 1
Preparation of Embroidery Machine
BES-941BC • BES-1241BC
27
4.
Mount four drilling bolts
i
, spring washers
!
0
, flat washaers
!
1
each on the rear of F table R
t
, M
y
, and L
u
.
5.
Mount four thumb bolts on the steel pipe below the front leg.
6.
Insert the pins attached to the rear of the F table R
t
, M
y
, and L
u
into the cover
o
on the
leg.
Adjust the height of the F table guide U
q
and the F table support F
e
so that the table
top surface will become 1 mm lower than the bed top surface.
After adjustment is finished,
tighten each bolt securely.
7.
Mount a drilling bolt
i
, a spring washer
!
0
, and a flat washer
!
1
in section (A) of F tables R
t
and L
u
.
q
e
Lower by 1 mm
Pin
i
o
u
y
t
(A)
(A)