Brother International HL-1260 Service Manual - Page 161

7. STATUS MESSAGE LIST Table 6.1 Operator Call Messages Operator Call Message CHECK XX TRAY 12 COVER OPEN 13 JAM XXXXXX 14 NO CARTRIDGE XX NO CASSETTE 16 TONER EMPTY Meaning The paper cassette (XX is MP/T1/T2) is out of paper. The upper cover of the printer is open. Paper is jammed in the printer. XXXXXX is TRAYS/ INSIDE/REAR/DUPLEX. The toner cartridge is not installed in the printer. The paper cassette is not installed. XX is T1/T2. The printer has almost run out of toner: you may print another 30 to 100 pages. (The ALARM lamp lights at the same time.) Action Load a stack of paper into the cassette. See M-7. Close the cover. See M-6. Remove the jammed paper from the indicated area. See M-10. Install a toner cartridge. See M-8. Install the paper cassette. Remove the toner cartridge, rock it several times at 45°, and install it again. Or replace the toner cartridge with a new one. See M-9. XX LOAD PAPER ***** SIZE 18 MANUAL FEED ***** SIZE 19 CHECK FONT The wrong size of paper was loaded in the paper cassette XX. XX is MP/ T1/T2. (The message appears alternately to show a particular size.) The printer requests you to load paper manually. (The message appears alternately to show a particular size.) Load the requested size of paper in the paper cassette, or load it on the manual feed tray and press the FORM FEED switch. Load the requested size of paper on the multi-purpose tray and press the SEL switch. An error occurred in the optional font cartridge/card. Turn off the printer, and reinstall or replace the optional font cartridge/card. 20 FONT REMOVAL 27 NO DX UNIT 27 NO DX TRAY 27 DX OPEN The font cartridge/card was removed while the printer is on-line. Turn off the printer, install the font cartridge/card, and turn on the printer. The CONTINUE switch will allow you to temporarily ignore this message. The duplex unit is not installed with the printer when the duplex printing mode is selected. The duplex paper guide tray is not installed in T1 when the duplex printing mode is selected. The cover of the duplex unit is open. VI - 9 Install the duplex unit correctly.See the DX-1200 /DX-1600 user's guides. Install the duplex paper guide tray into T1. See the DX-1200 /DX-1600 user's guides. Close the cover. See the DX1200/DX-1600 user's guides.