Brother International Innov-is NQ1700E Operation Manual - Page 52
Touch panel is malfunctioning, Replacing the embroidery foot
View all Brother International Innov-is NQ1700E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Care and Maintenance ■ If there is no screw in the needle plate cover 1 Grasp both sides of the needle plate cover, and then slide it toward you. Insert the tabs on the needle plate cover into the k needle plate, and then slide the cover back on. Reattach the bobbin cover. Grasp the bobbin case, and then pull it out. h Use the cleaning brush or a vacuum cleaner to remove i any lint and dust from the race and bobbin thread sensor and the surrounding area. c 1 Cleaning brush 2 Race 3 Bobbin thread sensor a b Note • Do not apply oil to the bobbin case. Insert the bobbin case so that the mark on the j bobbin case aligns with the mark on the machine. a b a b • Align the and marks. CAUTION • Never use a bobbin case that is scratched or has a burr on it. Otherwise the upper thread may become tangled, the needle may break or stitching performance may suffer. For a new bobbin case, contact your nearest Brother authorized service center. • Be sure that the bobbin case is correctly installed, otherwise the needle may break. Touch panel is malfunctioning If the screen does not respond correctly when you touch a key (the machine does not perform the operation or performs a different operation), follow the steps below to make the proper adjustments. Holding your finger on the screen, turn the main a power switch to OFF and back to ON. The touch panel adjustment screen is displayed. Lightly touch the center of each +, in order from 1 to 5. b +1 +4 +5 +2 +3 Turn the main power to OFF, then turn it back to ON. c c 1 mark 2 mark 3 Bobbin case • Make sure that the indicated points are aligned before installing the bobbin case. 50 Replacing the embroidery foot CAUTION • Only use embroidery feet designed specifically for this machine. Use of any other embroidery foot may result in injuries or damage to the machine. Press (Needle position button) once or twice to a raise the needle.