Brother International KE-436C Instruction Manual - English - Page 40
SEWING, 7-1. Before starting sewing...., 7-2. Sewing operation
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
7. SEWING 7. SEWING CAUTION Turn off the power switch at the following times, otherwise the machine may operate if the foot switch is depressed by mistake, which could result in injury. • When threading the needle • When replacing the needle and bobbin • When not using the machine and when leaving the machine unattended Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in personal injury or damage to the machine. Note: At the time of shipment from the factory, this sewing machine is set to not detect needle up errors. If you would like needle up errors to be detected, set memory switch No. 14 to ON. 7-1. Before starting sewing.... Check that the needle bar is at its highest position. Turn the machine pulley so that the index mark (1) on the pulley is between the marks (2) on the belt cover. * If the machine is started while the index mark (1) is not between these two marks (2), error message "E.22" will be displayed. (only when memory switch No.14 is on) 7-2. Sewing operation 2462Q 1. Turn the power switch on. (The power indicator on the operation panel will light.) 2. Insert the floppy disk (1). 3. Press the PRO. No. selection switch (2) to select the desired program number. 4. Press R/W switch (3). • The floppy disk drive indicator will light and the program no. display (4) will show a "P" while the data is being read. When reading is completed, an alarm will sound and the indicator will go out, then the program no. display (4) will blink the program number. 2718Q 2719Q KE-436C 34