Brother International KE-436C Instruction Manual - English - Page 52
Work clamp interchangeability, 9-12. Adjusting the needle up stop position, To use the BAS-311E
View all Brother International KE-436C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
9. STANDARD ADJUSTMENTS 9-11. Work clamp interchangeability 2619Q The BAS-311E, 311F work clamp can also be used with the KE-436C. Replace the feed bar guide cover (1) with the feed bar guide cover assembly, LL (2) (optional). Then, change the installation position for the presser arm assembly (3) from the standard installation position A to installation position B. To use the BAS-311E, 311F work clamp and the KE436C work clamp interchangeably Use the optional work clamp 434EMK2 air (5) with the KE436C work clamp. It can then be used interchangeably with the BAS-311E, 311F work clamp (6) at installation position B. 2620Q 9-12. Adjusting the needle up stop position The needle up stop position is adjusted so that the index mark (2) on the machine pulley (1) is inside the mark (4) on the belt cover (3). If adjustment is necessary, loosen the screw (5) at the "U" mark of the machine pulley (1) and adjust the position of the machine pulley (1). The machine pulley (1) stops later if it is turned clockwise, and it stops earlier if it is turned counterclockwise. Note: The screw (6) at the "D" mark is an adjusting screw for the needle down detection function and is adjusted to match the feed timing, so it should not be loosened. The screw (7) is a screw for detecting the machine stop position, and should not be loosened. * If the index mark (2) is not inside the mark (4) when the sewing machine is started, error code "E.22" will be displayed (when memory switch No.14 is on). Turn the machine pulley to move the index mark (2) to the correct position and then start the sewing machine. 2576Q KE-436C 46