Brother International MFC-J4710DW Network Users Manual - English - Page 23
For MFC-J2510/J4510DW/J4710DW, Network, Add a wireless device, Control Panel, Network and Internet
View all Brother International MFC-J4710DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Configuring your machine for a wireless network (For MFC-J2510/J4510DW/J4710DW) 3 a Press . b Press Wi-Fi. c Press WPS w/PIN Code. 3 d When Switch Network interface to wireless? is displayed, press Yes to accept. This will start the wireless setup wizard. To cancel, press No. e The LCD will show an 8 digit PIN and the machine begins searching for a WLAN access point/router for up to 5 minutes. f Using a computer that is on the network, type "http://access point's IP address/" into your browser. (Where "access point's IP address" is the IP address of the device that is used as the Registrar 1.) Go to the WPS (Wi-Fi Protected Setup) setting page and input the PIN which the LCD shows in e to the Registrar and follow the on-screen instructions. 1 The Registrar is normally the WLAN access point/router. NOTE The setting page may be different, depending on the brand of WLAN access point/router. See the instruction manual that came with your WLAN access point/router. If you are using your Windows Vista® or Windows® 7 computer as a Registrar, complete the following steps. NOTE To use a Windows Vista® or Windows® 7 computer as a Registrar, you need to register it to your network in advance. See the instruction manual that came with your WLAN access point/router. 1 (Windows Vista®) Click , Network, and then Add a wireless device. (Windows® 7) Click , Control Panel, Network and Internet, and then Add a wireless device to the network. 2 Choose your machine and click Next. 3 Input the PIN from the printed page and then click Next. 4 Choose your network that you want to connect to, and then click Next. 5 Click Close. 17