Brother International SE425 Operation Manual - Page 106
Position the fabric so that the opening of
View all Brother International SE425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
UTILITY STITCHES Determine the desired length of the bar tack. a Set the button guide plate on buttonhole foot "A" to the desired length. (The distance between the markings on the presser foot scale is 5 mm (3/16 inch).) 1 • Pass the upper thread down through the hole in the presser foot. 2 3 a Presser foot scale b Length of bar tack c 5 mm (3/16 inch) Memo z A bar tack with a maximum length of about 28 mm (1-1/8 inches) can be sewn. Note z When lowering the presser foot, do not push in the front of the presser foot, otherwise the bar tack will not be sewn with the correct size. Attach buttonhole foot "A". b • For details on replacing the presser foot, refer to "Replacing the presser foot" (page 43). Select stitch 60 . c • For details, refer to "Selecting stitching" (page 49). a a Do not reduce the gap. Pull down the buttonhole lever as far as e possible. Position the fabric so that the opening of the d pocket faces toward you, and then lower the presser foot lever so that the needle drops 2 mm (1/16 inch) in front of the pocket opening. 1 a 2mm (1/16 inch) 104 a a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. a b a Buttonhole lever b Bracket