Brother International SE425 Operation Manual - Page 79
sewing machine.
View all Brother International SE425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Raise the presser foot lever to check that the d side cutter is securely attached. Pass the upper thread under the side cutter, e and then pull it out toward the rear of the sewing machine. Position the fabric in the side cutter. h The cut in the fabric should be positioned over the guide plate of the side cutter. Select a stitch. f • For details, refer to "Selecting stitching" (page 49). a a Guide plate Memo z If the fabric is not positioned correctly, the fabric will not be cut. 3 Lower the presser foot lever, and then start i sewing. Make a cut of about 2 cm (3/4 inch) long in g the fabric at the beginning of the stitching. 1 a 2 cm (3/4 inch) X A seam allowance is cut while the stitching is sewn. Memo z If the stitching is sewn in a straight line 63 , the seam allowance will be about 5 mm (3/16 inch). 1 a 5 mm (3/16 inch) z The side cutter can cut as much as one layer of 13-oz. denim. z After using the side cutter, clean it by removing any lint or dust. z If the side cutter can no longer cut fabric, use a rag to apply a small amount of oil to the cutting edge of the cutter. Overcasting Stitches 77