Brother International SE425 Operation Manual - Page 28
even if the thread become tangled under
View all Brother International SE425 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
GETTING READY Cut the thread with scissors, slide the bobbin o winder shaft to the left, and then remove the bobbin from the shaft. ■ When the thread became tangled under the bobbin winder seat. If the bobbin winding starts when the thread is not passed under the pretension disk of the bobbinwinding thread guide correctly, the thread may become tangled under the bobbin winder seat. In such a case, wind off the thread according to the following procedure. Memo z If the bobbin winder shaft is set to the right side, the needle will not move. (Sewing is impossible.) Slide the sewing speed controller back to its p original position. Memo z When the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction. b a a Thread b Bobbin winder seat CAUTION ● Do not remove the bobbin winder seat even if the thread become tangled under the bobbin winder seat. It may result in injuries. ● Do not remove the screw of the bobbin winder presser, otherwise the machine may be damaged; you cannot wind off the thread by removing the screw. a a Screw of the bobbin winder presser If the thread become tangled under the bobbin a winder seat, press (Start/stop button) once to stop the bobbin winding. When the foot controller is plugged in, remove your foot from the foot controller. a a Start/stop button 26