Brother International SE625 Operation Manual - Page 59

4 Chapter EMBROIDERY Embroidering Preparation Embroidering Preparation Follow the steps below to prepare the machine for embroidery. Step 9 Step 3 Step 1, 2 Step 5 Step 4 Step 6 Step 7, 8 Step Aim # Action Page 1 Presser foot Attach embroidery foot "Q". 57 attachment 2 Checking the Use needle 75/11 for 22 needle embroidery. 3 Embroidery unit Attach the embroidery unit. 58 attachment 4 Bobbin thread For the bobbin thread, wind 13 setup embroidery bobbin thread and set it in place. 5 Fabric preparation Attach a stabilizer material to 60 the fabric, and hoop it in the embroidery frame. 6 Embroidery frame attachment Attach the embroidery frame 62 to the embroidery unit. 7 Pattern selection Turn the main power to on, 63 and select an embroidery pattern. 8 Checking the Check and adjust the size and 64 layout position of the embroidery. 9 Embroidery Set up embroidery thread 65 thread setup according to the pattern. Attaching the Embroidery Foot CAUTION • Be sure to use embroidery foot when doing embroidery. Using another presser foot may cause the needle to strike the presser foot, causing the needle to bend or break and possibly cause injury. Press (Needle position button) to raise the needle. a Press . b → The screen changes, and all keys and operation buttons are locked (except ). Remove the presser foot and presser foot holder. c • For details, refer to "Replacing the Presser Foot" on page 23. 4 EMBROIDERY Hold the embroidery foot "Q" with your right hand, as d shown. Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot. b a 1 Lever 2 Embroidery foot bar 57