Brother International SE625 Operation Manual - Page 87
After sewing
View all Brother International SE625 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Troubleshooting Symptom, Cause/solution Reference Skipped stitches Machine is threaded incorrectly. 13, 17 Using improper needle or thread for the selected 21 fabric. Needle is turned, bent or the point is dull. 22 Needle is installed incorrectly. 22 Dust or lint has collected under the needle plate. 77 Thin or stretch fabrics are being sewn. 32 • Attach stabilizer material to the fabric. Not stitching Needle is turned, bent or the point is dull. 22 Bobbin is set incorrectly. 16 Upper threading is incorrect. 17 High-pitched sound while sewing Dust or lint is caught in the feed dogs. 77 Pieces of thread are caught in the race. 77 Upper threading is incorrect. 17 A bobbin designed specifically for this machine is 13 not used. There are needle holes or friction scratches in the * bobbin case. Fabric does not feed through the machine. Feed dogs are set in the down position. 5 • Slide the feed dog position switch to the right ( ). Stitches are too close together. 29 Wrong presser foot was used. 23 Needle is turned, bent or the point is dull. 22 Thread is entangled. 80 Zigzag foot "J" is slanted on a thick seam at the 32 beginning of stitching. The fabric feeds in the opposite direction. The feed mechanism is damaged. * The needle contacts the needle plate. The needle clamp screw is loose. 22 Needle is turned, bent or the point is dull. 22 Symptom, Cause/solution Reference Fabric being sewn with the machine cannot be removed. Thread is tangled below the needle plate. 80 A broken needle has fallen into the machine. • Turn off the machine, and remove the needle 80 plate. If the needle that fell into the machine can be seen, use tweezers to remove it. After removing the needle, return the needle plate to its original position and insert a new needle. Before turning on the machine, slowly turn the handwheel toward you to check that it turns smoothly and that the new needle enters through the center of the needle plate opening. If the handwheel does not turn smoothly or the needle that fell into the machine cannot be removed, consult your authorized Brother dealer or the nearest Brother authorized service center. The handwheel does not turn smoothly. Thread is tangled in the bobbin case. 77, 79, 80 ■ After sewing Symptom, Cause/solution Reference Thread tension is incorrect. Upper threading is incorrect. 17, 79 Bobbin is set incorrectly. 16, 79 Using improper needle or thread for the selected 21 fabric. Presser foot holder is not attached correctly. 23 Thread tension is set incorrectly. 29, 79 Bobbin thread is incorrectly wound. 16 Needle is turned, bent or the point is dull. 22 A bobbin designed specifically for this machine is 13 not used. Decorative stitch patterns are misaligned. Wrong presser foot was used. 35 Stitch pattern adjustment settings were set 54 incorrectly. Stitch pattern is irregular. Wrong presser foot was used. 23 Thin or stretch fabrics are being sewn. • Attach stabilizer material to the fabric. Thread tension is set incorrectly. 32 29, 79 APPENDIX 5 85