Canon LV-5200 Owners Manual - Page 38
Appendix, Caution - bulb
![]() |
View all Canon LV-5200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
APPENDIX LAMP REPLACEMENT LAMP REPLACE When the life of the Projection Lamp of this projector draws to an end, the LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the Projection Lamp with a new one promptly. This indicator lights yellow when the life of the Projection Lamp draws to an end. Replace the Projection Lamp with a new one promptly. TOP CONTROL Y NE LAMP REPLACE LAMP US WARNING TEMP. Allow the projector to cool, for at least 45 minutes before you open the Lamp Cover. The inside of the projector can become very hot. CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect the AC plug. Allow the projector to cool for at least 45 minutes. 2 To remove the Lamp Cover, remove the screw with a screwdriver. 3 Loosen 3 screws with a screwdriver and pull out the Lamp Assembly by grasping the Handle. 4 Replace the Lamp Assembly with a new one and tighten 3 screws back into position. Make sure the Lamp Assembly is set properly. Replace The Lamp Cover and tighten the screw. 5 Connect the AC Power Cord to the projector and turn on the projector. 6 Reset the Lamp Replace Counter. Refer to the "LAMP REPLACE COUNTER" on the next page . LAMP COVER SCREW LAMP ASSEMBLY SCREW HANDLE ORDER REPLACEMENT LAMP The Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer. G Model No. of your projector : G Replacement Lamp Type No. : LV-5200 LV-LP16 (610 303 5826) 38
![](/manual_guide/products/canon-lv5200-owners-manual-7ee5cb3/38.png)